Slip Grip

Non-Slip Tile Treatment

Slip Grip

Non-Slip Tile Treatment

Increase the Safety of Your Floor with Slip Grip

Slip Grip is a clear liquid treatment designed to reduce slipping on floors, particularly when they are wet. Many masonry and tiled surfaces are naturally smooth and therefore represent significant risks, especially on slippery floor. However, with Slip Grip, this same surface can become much safer to walk on.

How Slip Grip works as an anti-slip tile treatment

Slip Grip works by microscopically increasing the roughness of the surface, giving it ‘grip’. The change is not visible to the naked eye, but as the smoothness of the surface is reduced, some surfaces may become a little dull. A test patch is recommended to check that any change in surface appearance is acceptable.

Where you can use Slip Grip

Slip Grip is designed to work on slippery masonry floors. Smooth masonry surfaces like ceramic tiles, granite or marble floors, driveways and garden paths, most commonly found in bathrooms, kitchens, pool surrounds, entry foyers and patios. Slip Grip can be used indoors and outdoors and is not affected by UV light. Not suitable for porcelain surfaces.

Specific Surface Types

marble stone

Stone floors - granite, slate, marble, limestone, etc.


Ceramic, terracotta pavers


Tiles - glazed or unglazed, mosaic, quarry or terrazzo


Concrete - unpainted or unsealed




Driveways and garden paths

Application Process

How to use Slip Grip to reduce the risk of slipping on wet, tiled, paved, stone or concrete floors.

Slip Grip is applied in three coats and then washed off. The effects are immediate and effective both indoors and outdoors. It can also be reapplied at any time to increase grip.

You Will Need
clean surface

Cleaning products to clean the surface before and after Slip Grip


Brush or roller to apply Slip Grip

slip grip

Slip Grip; at a ratio of 1L to cover 10m²

towel clean

Towel or wet vacuum for drying the surface

1. Prepare the surface

Clean the slippery surface thoroughly and wipe until dry. Tape and cover any areas that should not be treated.

cleaning preparation

2. Test on a small section

Test on an inconspicuous section of slippery floor and ensure the results are acceptable in appearance and grip.

To test, slide a damp cloth/paper towel from untreated area to treated area. Surface should 'grip' cloth at treated area.

Follow the three-coat, wet-on-wet application process given below.

Proceed to next step if satisfied with test.

3. Application of Slip Grip

Using a sponge, brush or roller to apply Slip Grip evenly:

  • Apply first coat. Wait five minutes.
  • Apply second coat. Wait five minutes.
  • Apply third coat. Wait five minutes.
  • Wash off thoroughly with water.

The surface is now ready to use. Grip can be increased with further applications as above.

Wash equipment in cold water.

sponge cleaning

Purchase Slip Grip now

Reduce the risk of slipping on wet or slippery bathroom floor with Slip Grip.
Purchase now through our website and enjoy the convenience of shipping Australia wide.

Treats 2m²

Slip Grip 200mL

Treats 10m2

Slip Grip 1L

Covers 40m2

Slip Grip 4L

Covers 200m2

Slip Grip 20L